Search results


  1. joe_thompson

    b16a2 engine

    Yes, im just after the block with crank caps :)
  2. joe_thompson

    b16a2 engine

    Hey guys, im after a b16a2 bottom end or engine. Let me know! 0790 950 70 10 Thanks :)
  3. joe_thompson

    b20 turbo ek9....bare shell up

    Well after doing more and more research it did seem that using a b16 would be the most cost effective way of doing what I wanted. My engine build will be strong enough to handle more power than I will ever want too should be good :) :drive:
  4. joe_thompson

    b20 turbo ek9....bare shell up

    Gave the 9 abit of a clean as dust seemed to be collecting, also took it off the trailer for the first time in months! Just so you know the right hight is not set up at all neither is any of the suspension geo, just incase you guys wonder whats going on ;) The engine isnt far off...
  5. joe_thompson

    So i brought a new car! anyone guess?

    its a 996, i dont pick it up untill tomorrow so not yet im afraid!
  6. joe_thompson

    So i brought a new car! anyone guess?

    Had a 911 Carrera s2 :) boxters are a very good car! they are ment to handle really well! Well im sure I will find out about the running costs haha
  7. joe_thompson

    So i brought a new car! anyone guess?

    :( that game didnt last very long!
  8. joe_thompson

    So i brought a new car! anyone guess?

    Its rear wheel drive, over 2L engine not jap though! Lets hear your guess's?
  9. joe_thompson

    Nurburgring Honda CRX and an angry driver

    Thats made my day!
  10. joe_thompson

    b20 turbo ek9....bare shell up

    Nice one! always good to hear some positive comments :) :dance:
  11. joe_thompson

    b20 turbo ek9....bare shell up

    Pistons and rods are second hand which i got for a steal! But are in good enough condition Cleaned them all up and polished the tops One of the main reasons the project got put on hold was due to moving into a new workshop, so dont think im just steeling someone else's photos ;)...
  12. joe_thompson

    b20 turbo ek9....bare shell up

    Literally not done much on my build for ages! Been really busy with work and studies which unfortunately come first :( But started back up working on it again. Also had a few chances to the project: No longer using a b20 engine, iv decided to go to a b16 as it seems to be more cost effective...
  13. joe_thompson

    Im back!

    I did loose the enthusiasm to carry on but! i have rekindled the love and im going to finish it off! Been really busy with my studies and work too.
  14. joe_thompson

    Im back!

    :dance: Well its been a fair while since I was last active on this forum and same goes for doing any work on the EK9. That's all going to chance. Decided im going to finish the civic! I will get some update on the good ASAP
  15. joe_thompson

    Light weight Door cards and Low Position Subframes

    Bump, Still got everything available.
  16. joe_thompson

    April Fools day - needs to be stopped!

    hahahah, i was so confused! You got me :)
  17. joe_thompson

    Rear engine mount bracket!

    As above, im after a rear engine mount bracket for a b16 engine (ek4/ek9) pm me Thanks
  18. joe_thompson

    B16 ek throttle cable

    As above! what you got?
  19. joe_thompson

    Light weight Door cards and Low Position Subframes

    Bump still doing these!
Back
Top