Recent content by stezie

I sent you a few pictures there.

Glad to hear is still alive and still looking good! PM me your email address and I'll email over a few pictures from when I had it.

https://ek9.org/index.php?threads/any-info-on-my-ek9-99c29853.78774/

I haven't been on this forum for a while. bet you have given up looking for it at this stage. When did you own this car? I owned it around jan 2013 - feb 2014. I bought it as a bare shell. Built it up again. Had some fun on track days and it was a really mint car when I sold it again. Not sure...

Carbone lorraines are expensive, but really effective.

A plain brake disc, from a motor factor with a decent set of quality brake pad is what I would recommend.

sound, i dont have the exhaust off at the minute, so will get those measurements for you later

Tried that

i dont see any there.. its not the 2.5" donut ring i need.. its the two rings i need. if you find a link can you send it to me??

My exhaust manifold is leaking at the joint between the manifold and the down pipe. I need to 2 round compression gaskets. any one know the part number for these, or where to try and source them?

When I put my EK9 through the test, I removed the airbag ECU, taped up any SRS stickers and put the dashboard panel into a black pillow case and put it back into the dash. didnt look half bad either. I was asked about the airbag panel, and no airbag light on dash, so i pulled the panel out and...

Nothing worse than a randomn fault... :nono: Car started up just fine there now and drove back to house.

Crikey! Cheers for the heads up. Did you change the dizzy as a unit or just the coil or ignitor in dizzy itself?

So yesterday my car died out in the middle of a roundabout, with no warning. No misfire, no running rough, no ecu light.. When I tried to turn it over, it doesn't start, just pops and bangs, just like in the video below. I towed the car home and got a lift to work. After work, I tried the car...

a stretch bolt tool you say.. hmmm more homework..