kwstascivic b20


start the bulding

DIY :drive:

HPIM9573.jpg


HPIM9576.jpg


HPIM9582.jpg


HPIM9579.jpg


HPIM9580.jpg


HPIM9585.jpg


HPIM9590.jpg


HPIM9598.jpg


HPIM9600.jpg


HPIM9602.jpg


HPIM9603.jpg


HPIM9605.jpg


24112014273.jpg
 
  • Like
Reactions: rvm
Engine Specs ?

Head Milling and Block Decking ---->0,8
B20b
Wiseco pistons 84,5mm 11,5:1
Eagle rods
itr head light ported
Endyn Bump stix cams
Blox ported intake manifold
s90 70mm Throttle Body
evo 8 550cc Injectors
ITR oil and water pump
golden eagle vtec kit
Thermal intake gasket
APR headstuds
Acl race bearings
Walbro 255lph fuel pump
Custom 3" short ram
hks air filter
hytech big tube
nology leads
Custom clutch
Fidanza lightweight flywheel
b16 transmission
3'' custom exhaust
 
  • Like
Reactions: rvm
good build man want to build a b20 myself at some stage too.. correct me if im wrong but i tought the intakes are supposed to have rough surfaces inside to create a swirl pattern for a better air/fuel mixture instead of a smooth surface?
 
Bump stix cams are quite rare, Endyn doesn't make them any more I believe?! Should make nice power with that engine spec. Keep us posted on results :nice:
 
good build man want to build a b20 myself at some stage too.. correct me if im wrong but i tought the intakes are supposed to have rough surfaces inside to create a swirl pattern for a better air/fuel mixture instead of a smooth surface?

Well i think you are reffering to the "golf ball" effect.
The first think to make the head is thw "wave" style cut like 4piston heads.
Of you cant do that cause it super expensive its allways better to have the ports
cleaned and smooth cause most intake manifolds come uneven non identical holes.
 
  • Like
Reactions: rvm
Bump stix cams are quite rare, Endyn doesn't make them any more I believe?! Should make nice power with that engine spec. Keep us posted on results :nice:

Yeah its a good cam.My tunner said they give VERY nice results.
I will update with results dynograph soon
 
Back
Top