Oil catch can set up - pic request

[ramboteamjon]

mmmmmmmmmm weird!

 

[Vtec6000]

hmm i still cant seem to find mine:? theres nothing to plug it into ? ive already got something plugged into the top of that though?

edit:

ive found it, but its got something connected to the block already?

There is another port in past that which the breather pipe from you I.M goes to

 

[lance]

There is another port in past that which the breather pipe from you I.M goes to

Thats the thick black one you see near the middle of the screen. There's only those 2 sockets from the black box :/

 

[hondatuner208]

This is my setup

I had the top of the can tapped so I could screw in a fitting and attached a pipercross breather to that. The bracket is attached to the battery tray to avoid drilling into the bodywork. The two hoses attach to the valve cover and the PCV valve (The red thing on the intake manifold or on the black can on the back of the block) although I will be bypassing this in the future directly into the black can.

Just wondering, wat all did you use for this set up like the lines, bracket to mount the tank, bolts, wat you use to attached the lines to the tank, and wat you used to attach the breather to it please? I have the same tank and just wondering watcha use so i can install it. Much appreciated!!

 

[hondatuner208]

Bump please

 

[danger_day]

Correct, should give you plenty breathing for a standardish setup

one hose from rocker to breather
one hose from black box to breather

cap off PCV vacuum on inlet manifold
cap off valve cover breather hole on intake pipe

Only once you go high compression / turbo etc when you need to consider much more advanced breather setups

I know its a revival of an old thread but better to do than than clog the forum up with a new one.

Might sound really stupid but how do you cap off the PCV vacuum and valve cover?

 

[ali-c]

With silicone hose end caps. like these.....

Think the pcv and intake arm hole are 10mm

Silicone Hose End Caps 2 Pack - Blanking Plug Bung Rubber Finisher Steel Braided | eBay

 

[danger_day]

Ah thank you very much . I gave you reputation.

 

[Kristian_EJ9]

i know this is a old topic but what size fitting will fit the blackbox , where the pcv valve was

 

[irf]

i know this is a old topic but what size fitting will fit the blackbox , where the pcv valve was

Pretty sure it's a -8 AN. Push it in tight with some tiger seal on it, Will never come off.