Engine swap electrics


mad kiwi

mad kiwi

New Member
Joined
Jun 30, 2013
Messages
4
I have a B16B engine in my EG civic. The conversion was carried out by someone else.
It has a ECU with the following numbers 37820-P28-GOO 766-105589. I am told that the insdes of this are re mappable.
I do not know what engine to ecu loom is being used.
Is this the correct ecu for the engine?
If not, what is the correct one. I dont care for re programmable.
Is there any way that I can identify the loom being used is the correct one.
Thanks in advance
B
 
your ecu is from a obd1 loom so its not the correct ecu to run with a b16b as that would be obd2a/b depending. the correct ecu should be PCT. if you look at where the ecu is connected to the loom is it only one set of connecions ? or does it connect into the ecu then there another connection shortly after ? that would be a conversion harness to be able to run that ecu which id imagine yours has ?
 
Its not gonna have a conversion jumper harness because the car is obd1 and the p28 is obd1 also..
Just open up the ecu and see what kind of chip do you have
 
You must log in or register to reply here.
Back
Top