passenger side is from EK9, driver side is obviously not as it is height adjustable? Not sure what brand, i was told it is a spoon rail. I will have to take it off and have a look if you are genuinely interested.
I need some DC2 Rails...
I have some EK rails for swaps if needed, the drivers side is height adjustable so can go down low...I will need money my way if you want swaps and need to be local. I am based in Slough near Heathrow airport.
worth a shot as someone may have some spare, but im after some DC2 Rails. I can sort out some EK rails (lower driver side rail) in exchange plus money my way if required.
its ok, i found the answer in a couple of threads below where someone has stated DC2 98 spec, UKDM DC2, EK9 all use same pads! Therefore, we can also add to the list Prelude 282 pads ;) sorted and thanks for your help.
true, but then isnt the ECU designed to work with that dual runner double intake cr@p lol so i would think the engine wouldnt run well with a ITR intake and cams on the standard ecu?
Bought some mirror off this guy and he packed them up very well and sent them out quickly. Great communication and trusted member. Would deffo deal again with no worries!
unless you have a lot of money to spend, there is no quiet exhaust which does not drone for a honda. What i would recommend is a EK9 backbox if you are after a nicer look for ur EK4. If ur after power gains without a large wad of money, from what i have tried and read, the only way is a loud...
this is true, but i think the idea was to keep the exhaust volume down and trying to gain as much power without increasing noise (that was my idea anyway)!