Search results

Yea, I'm just going to opt for an obd1 p28 chipped with a jumper harness. Too much of a hassle messing with a transistor and have everything not work properly.

Yeathe tests were done in a warm garage. I tried checking the circuit board on the ecu and I don't think I'm getting continuity from the board to the pin that enters the terminal on the harness plug. I also tried checking that sk5151 high side transistor switch that like to go bad, and only one...

So I've linked all of those wires to the thermostat housing for grounds. I've checked the ect sensor plug feeds out 5v, I've checked the ect sensor for resistance, however as stated in the manual when cold it should feed out 5,000, but it only fed out 2,000-3,000 and feeds out 230-250 ohms when...

Hello I'm back again, I found these harness grounds, are they all grounds or what ? 2 wires are brown with a black line, and 3 wires are all black.

Thanks Lee, I appreciate it.

Hello, I have an EK4 Vti that came with the original b16a2 obd2 but spun a rod so I sourced another b16a2 and I'm getting codes 21 and code 6. I found a cut wire on the thermostat plug and got it re soldered, due to the fan not kicking on. Now the fan kicks on but the code still appears (code...

Yes, thank you so much. I should plug that knock sensor plug/prong back in ? And yes that wire is blue and red, followed it back to the mini fuse box near the air filter.....Another thing..... When I turn the key to the "on" position cel does not come on and turn back off. Trying to pull the...

You can say so.....there a bit rare here, they have sedans, coupes and what not, but not too many hatches, even ek coupes and sedans are rare, but i see a few eg sedans. Thank for the compliment though, I'm so excited. :)

I know man, makes me sick.....lol, but uh, now that i inspected it closely, i think it might actually be that spray on tint BS. I seen a few youtube vids saying a little gas on a rag will take it right off. Might just give that a try, thx for the input though man.

Hello guys, I've got a rear taillight and side markers that have this horrible black tint on them. I'd like to remove the tint, i don't think its the spray on type, its a film type. Just trying to figure out what might be the best solution possible to eliminate the tint off ? As you can...

Appreciate it guys ! :)

Thank you rvm, really appreciate it. :nice:

Hey guys, Names Manny, new to the site, I actually just picked up an EK4 and as i'm roaming threw the engine bay, I notice 2 connectors unplugged on the back of the engine block right behind the oil filter......... The first plug is square, blue in color and has 6 prongs. I found this one...

Hello everyone, Names manny, just picked up a Ek4 Hatch with the b16a2 of course, she's got about 242 k (km) on her at the moment, she's got a lot ahead of her......will keep you guys posted. Once again, nice to meet everyone !