Search results

I almos forgot: The one in the left is the one in the VTi, or 9K scale, the one in the right is the 8K scale from an EX civic. As you can see the 9K scale has 0 ohm resistors in J2, J3, J4 and J6. They use 0 ohm resistors, but is just like a short circuit (or close to it, 0 ohm resistor have...

Sorry, but I don't know the value of the resistors for each scale. What I can tell you is that I had an 9K taco, and an 8K taco, and in the back they both had a place in the board where you can solder resistors in parallel, and the 8k taco had one less resistor than the 9K. I may be able to take...

You just put it over the original face. If you want to remove the face you have to remove the needle, and like I said, if you do this in the taco, you will break it. I did it before and I had to buy a new one. Later I disassemble the hole thing, and I learnt that the needle axis goes through a...

And it cost me 91 EUR, with shipping to Argentina included, the custom ones are the more expensive...

He does gauges from 87 to 2005 civic models. http://moman.pl/eu/civic,52,0.html I don't know if in the eg6 models the taco is removed in the same way than in the EK, but if you remove the hole cluster (wich is fairly easy in the EK), all you have to do is look at it from behind, and you will see...

I got them from an store in Poland called MoMan, look them up. It has international shipping, and you can order from the internet. It has several modes, or you can ask for a custom one like I did. All I had to do was send them my current gauges, and the design I wanted. Here are more pictures...

Hi guys, I wanted to show you my new acquisition. It is a custom made glow gauge for the civic. Is basicaly a type R gauge with a red mark on the vtec range, and the vti legend (mine is an EK4). Hope you like it:

Hi everyone. I've been doing some research for front disc brake replacement. So far most people seem to like Brembo and Centric discs over OEM, but they are basically the same. Then I came across this EBC disc brakes: I was wondering if anybody tried them. Theoretically the outer inlet for the...

Thanks. I´m from Buenos Aires.

This is a great idea!:bow: I know this is an old thread, but did you measure the impedance at 70-100MHz, and 500 1500 KHz? I think that you did measure it with the frequency analyzer, but I can`t see the values in the picture. Thanks! :thanks:

Hello everybody, my name is Leandro I'm from Argentina. I have a 98 Civic VTi Hatchback. Some pictures: A bit of work, and of course a mate: I would like to add that I've reading some posts in this forum and I found some of the best answers here. Also it looks like people in here really...

Hello from south America