Search results

I would like them 18x9.5. Or else i'll buy them new

My friend sold me his. These were fitted on a dc2.

Hi, I'm looking to buy a set of used Rays CE28N 18X9.5 ET22. The colour isn't important. I know that this size does not fit my ek9 but I'm asking for help, becasue can't find any. These are for my gtr r32. Thanks a lot mates! David

Here a photo of my ek9: https://fbcdn-sphotos-d-a.akamaihd.net/hphotos-ak-frc3/q85/s720x720/969755_10151569692558105_844660653_n.jpg

Thanks guys but I bought a set of volk.

Thanks JKK. I already saw them, two of them are 8" wide, not good for me. Thanks JohnOBrien8. Will talk to them

Thanks JohnOBrien8 I checked them but they're 4x114.3 and 17". They won't fit the ek9 as it's 5 stud. Desmonds or spoon SW388 are good too. They need to be 5x114.3 and 16x7. Thanks.

I prefer the bronze ce28n, anyone knows where I can buy them from please? Thanks

I'm looking to buy either black or white te37, or black or bronze ce28 wheels for my ek9. Size 16x7. Anyone? Thanks.

I'm from Malta, I don't think you know him. Here's a video of his car (he built it): https://www.youtube.com/watch?v=l5NjqaDEcSg

Thanks blinx. We still haven't done a leakdown test.

The coolant is ok. It does not go down and doesn't require topping up. It has the T1 catch can installed, the one with 3 filters on top. It has the cometic head gasket installed, and benson's sleeves. The block was bought from the states sleeved. My friend bought this engine already...

The oil it has is 10w60, and the tuner suggested to use 20w50. Any suggestions?

The engine has an oil pressure gauge installed, and its good

We just did a compression test. 3 cylinders are over 13bar, but cyl. no.2 was found 11.7bar. I think before removing the head, we better run a leak down test.

we are going to remove the head, sleeves fitted correctly...suppose. we used arp studs. will keep you updated. thanks

i didn't see the smoke because I wasn't there but my friend told me it was white smoke

it does have a bit side by side movement but it's normal. it does not have inwards and outwards movement

so what do you suggest for 300-450bhp?

Hi, my friend just built a b18c turbo. Yesterday he got it on the dyno to tune it. While reaching about 4,500 - 5,000 rpm ( reached 7psi ) HEAVY smoke was coming out of the exhaust, so the tuner stopped. We thought that the problem was the turbo seals because the smoke was coming out ONLY while...