Swaping b18cR into civic ee9


gennc

Member
Joined
Jul 9, 2009
Messages
47
Hi im new to obd0 cars

I have 99 civic still stock and b18cr
I planned to swap into civic ek but now im changing plan im.gonna buy a civic ee9 and swap b18c engine
My question is what i need for swap

I have complet b18c engine gearbox obd2a and obd2b engine wiring with obd2a or obd2b to obd1 because i want to use hondata to remap it
Also have twm itbs toda b cams ,type r shift linkage etc


The car is still complete with engine but soon hes gonna remove the engine
What should i take from it
Mounts axels what else ?
Thanks for helping
 
Mounts, and loom is no good to you, you will have to use the mounts and loom from the EE9

Gearbox wise depends on what you will be running, EE9 come cable box which you can bolt on to the b18

If you thinking of using any hydro box, for example the s80 that originally comes with the b18cr engine then you will need to get cable to hydro gearbox mount, hydro setup to run the box

On the ECU side, is your ECU Obd1 HONDATA??

If it is then you will need conversion harness from obd0-obd1, this allow you to run the 1 plug 4 pin 02 sensor
 
I talked with David from rywire and he told me to buy this conversation kit and i can use my obd2a loom
And im gonna use my s80 gearbox with hydro to cable conversation
Also im gonna use hondata because its build engine with itbs and i need to tune it
 

Attachments

  • Screenshot_2016-02-08-14-06-08.png
    Screenshot_2016-02-08-14-06-08.png
    1.2 MB · Views: 227
He just told me now that i need obd0 wiring harness to run this wiring adapter
Is it possible to run obd2 witing harness with odb2-0bd1 wiring harness to use hondata ecu and to use stock internal wiring
 
Buy a conversion harness that goes from obd0 to obd1. Also buy a conversion harness for the distributor.
Pretty much plug and play. You don't need the obd2 loom.
Edit, you will need the fan switch plug from the obd2 loom. that's it.
 
Back
Top