Zeta R setup help

Hello! I bought some Meister R Zeta R's last September for my project car and I've been playing around with the setup today. I'm having a little trouble with the ride height on the front... they don't go as low as I'd hoped! So I was wondering if anybody else had these coilovers and whether you had trouble with these too? Or maybe I'm being over ambitious with my expectations :S Although the rears go nice and low!

I've adjusted the bottom as it says to do in the manual, and screwed it in as far as it will go until it sits at the bottom of the cup. The only way I can think of getting it lower is to unload the spring... which I'd rather not touch lol

The fronts...


The rears...


The coilovers...

Looking at you picture I see you have no drive shafts in, do you have a engine in there?

I have Zeta Rs and the fronts on mine go just as low as yours at the rears.

April fools lol? No engine?

He's got no brakes either.

We got no engines ted!!!

THERE AT THE WAREHOUSE!!!

Yeah I had the eureka moment in the shower this morning... front end is missing a few hundred kilos haha it's been a long week...

I think the whole different springs rates thing threw me off as when I jack the rear up the wheels remain in their position, snug in the arches, even with no load on the springs, and I thought the fronts would be the same... But actually they are more effected by the weight of the car than the rears as the spring rates are different.