I have one of these rear reinforcement bars to fit in an EK4 hatch, are they bolted in from underneath up into the boot floor/chassis, or are they bolted from inside of the boot floor to the outside?
Would the hole on the chassis/boot floor threaded already if its not an EK9?
Thanks
Hi, as title really want a flywheel to go along with a clutch change.
Would prefer to collect from North London/Herts area and in good condition, no scoreing/cracks/warp.
Thanks
Hi, im after the front door windows for a prefacelift EK4, which has electric windows (not sure if electric or manual windows are the same?)
Preferably in North London, Hertfordshire.
Please contact me on here or 07432635748.
Thanks
Hi, not sure what section this should go in but wondering if anyone knows if the EK9 engine mounts are stiffer than EK4 mounts?
I have the part numbers for each:
EK4
50841-ST0-N10
50842-ST0-N10
50805-S04-000
50810-ST7-000
50824-S04-013
and EK9
50841-ST0-Z00
50842-ST0-Z00
50805-S04-000...
If you have an immobiliser chip in your current key, then you need one in any new key your are going to get cut, otgerwise it will only open the locks but not start the car.