Recent content by qiqi

Had you test drive the 86? try and you might find something.

You know what, The coilover of driver side should be 5-10mm taller than the passenger side. Cos you are sitting on the driver side and it balance the height of the car when you drive. But I mistakenly placing the shorter coilover on the driver side and taller on the Passenger side!!! AHHHH...

So RVM, you recon the prelude rear will fit? Cos tico_ek9 mention that as well? Can I use the hub only? cos i got the rotor, and caliper out of USDM DC5S. Any confirmation? Cheers guys

This is my current front setup using CRV front knuckle, rotor and calipers. it had 36mm hub which similar to the jdm 98 spec ITR. From the pic, when i put 17x7.5 wheel, the wheel is slightly coming out like half inch. Hopefully it is ok when on the ground without scratching. I am using...

You can keep ur 7/8 MC. but it is always better to get larger MC as you wan more stopping power. I recon the 1" MC is the best

Using the Ek shall do. But they wouldn't make much different for stopping distance. It only make the padel feel stiffer.

try this website as they had the biggest OEM honda brake setup. How to put X brakes on your car - K20A.org .:. The K Series Source . Honda / Acura K20a k24a Engine Forum

really? Tats cool. I got the rear disk :P but i heard someone saying you need the trailing arm and so on (i think thats for the drum setup) Splat, could you pm me how much it roughly cost if doing ur way? Act, I got a full set 5 stud came off the DC5 when i wreck the car. Do you think i can use...

Hi guys, currently I am doing 5 stud conversion to my 96 Civic ek. However, it is so hard to source the proper EK9 and DC2R 5 stud conversion in Australia. It almost impossible mission!! So, what I done is - using 96 CRV front knuckles, 282 rotor and caliper. They are pretty identical to the...