oifovo
Well-Known Member
- Joined
- Jan 11, 2011
- Messages
- 2,287
Hi guys,
So finally I have got my EK9 back on the road. There have been quite a few teething issues that are mostly sorted now but there's one thing I can't get to the bottom of. The EML comes on at around 4k RPM every time I drive the car. I've tried to check for codes by bridging the connector but there aren't any stored. It clears as soon as you shut off the engine, but comes back when you drive again? I have checked all electrical connections, swapped the O2 sensor for a spare one, still does it. There are no obvious issues with the car, power delivery and fuel consumption are fine as is idle etc... Anyone has any ideas what might be causing this issue?
So finally I have got my EK9 back on the road. There have been quite a few teething issues that are mostly sorted now but there's one thing I can't get to the bottom of. The EML comes on at around 4k RPM every time I drive the car. I've tried to check for codes by bridging the connector but there aren't any stored. It clears as soon as you shut off the engine, but comes back when you drive again? I have checked all electrical connections, swapped the O2 sensor for a spare one, still does it. There are no obvious issues with the car, power delivery and fuel consumption are fine as is idle etc... Anyone has any ideas what might be causing this issue?