- Joined
- Jan 29, 2008
- Messages
- 6,259
Hi
Had the head off my B18C for 4 new valves and stem seals. No damage was done to the engine it didn't blow up we where just investigating a top end rattle and while it was of changed the seals as it was burning oil.
Anyway we just finished putting it back together today turned it over and its pissing oil out every where between the head and the block.
And i mean throwing it out.....
Its mainly coming out round the back below the inlet manifold directly below the dizzy near the corner of the engine!
We're baffled.
Either the head gasket is wrong?
Put on the wrong way? highly unlikely...
Missing something? Definitely not the two dowels...
Or i don't f'in know! Either way its probably gona be a strip down....... AGAIN
Had the head off my B18C for 4 new valves and stem seals. No damage was done to the engine it didn't blow up we where just investigating a top end rattle and while it was of changed the seals as it was burning oil.
Anyway we just finished putting it back together today turned it over and its pissing oil out every where between the head and the block.
And i mean throwing it out.....
Its mainly coming out round the back below the inlet manifold directly below the dizzy near the corner of the engine!
We're baffled.
Either the head gasket is wrong?
Put on the wrong way? highly unlikely...
Missing something? Definitely not the two dowels...
Or i don't f'in know! Either way its probably gona be a strip down....... AGAIN