HELP SRS problem


ijwhiteman

ijwhiteman

Super Moderator
Donator
Joined
Jan 29, 2008
Messages
6,259
Today i removed my airbag from the drivers wheel to straighten up the steering wheel as it had been off a bit since having my tracking done. Did the norm dis connect the battery do the work reconnect it. Test that the wheel is straight yep not right so did the same again then reconnected everything went for a drive and the SRS light on my dials won't go out....

Any ideas? :angry:
 
Thanks mate that really did help also helped me to find this...

Reset Your SRS Light

--------------------------------------------------------------------------------

How to reset your SRS light on your civic. This works for 99-00 Civic's as well as 2k1's. What is pictured is actually a 2k1 but the plug for the 99-00's are in the fuse box also, just on the other side of the column.

1st you need to either buy or make the "SCS Service Connector" #07PAZ-0010100 from H and A Accesories for $3.51. I used a speaker harness for an older Honda which you can buy at a local stereo shop such as Circuit City or Best Buy, and cut the wires and looped them together. You can also use a paperclip but that will make it a little more difficult because you have to connect it and disconnect it a few times quickly.

2nd you need to find the MES (Memory Erase Signal) connector which is pictured below: (Click to enlarge)


MES Plug in Fuse box.
SCS Plug

It is a yellow connector with two wires in it that is plugged into the fuse box, unplug it and pull it down. Once you have done that you can begin the process of erasing the memory. NOTE: This will only reset your SRS System if what caused it to trigger has been fixed, Ex: turning the ignition on with any SRS Plugs disconnected, such as pulling your seat out.

1st step in erasing the memory is to turn the ignition off and connect the SCS Service connector to the MES Plug,

2nd Turn Ignition on. SRS indicator light will come on for about 6 seconds then go off.

3rd Disconnect SCS service connector for MES connector within 4 seconds after SRS indicator light goes off. SRS indicator light will come on again.

4th Reconnect SCS service connector the MES connector within 4 seconds after SRS light comes on. SRS indicator light will go off.

5th Disconnect SCS service connector from MES connector within 4 seconds. SRS indicator light will indicate that memory is erased by blinking 2 times.

6th Turn ignition off, and wait 10 seconds. Start vehicle like normal and light should come on and go out like normal. You have reset your SRS light

The link

Reset Your SRS Light - Electronics - Honda Civic Forum
 
Which one is the MES,

SDC10341.jpg


The one on the right in my hand or the yellow one in the background?
 
You must log in or register to reply here.
Back
Top