Recent content by terry_em1

Aftermarket is fine. I have a 200 cell cat and it passes emissions.

I dunno if that'll affect your MAP sensor or IAT sensor. Best you check everything over and give it another go. My car failed emissions because the cat was nonexistent. The whole inside left the chat.

Could be your cat. Throw some Cataclean into the car. Would help some bit.

I'm already aware of the Honed kit. Just didn't know what to do with the front. Too late now :angry: Have some tasty wheels on the way from Japan.

Wish I seen this thread or knew this info before buying 4 stud wheels.

Less than retail on the brand new parts. I bought a low mileage Fidanza flywheel for my B-series for less than €200.

Impossible to put heatshrink on. I cut off some of the sheathing. Put an open barrel splice over the exposed copper. Threaded in the wire from the Defi. Pressed them suckers together. I used some tesa tape, so it should be good.

Finishing up on the Defi install today. I ditched this... ...for this. EK9 cupholders. The EM1 badly needed cupholders because: 1. Theres no spot to put drinks, apart from the armrest and the rear plastics. 2. I don't want to neck every drink I get before I drive It makes a good home for the...

I'm using a 96 spec DC2 distributor on my EM1. No issues. Different style module than normal. I have to use a bigger size distributor cap. Thats all.

Small update. I addressed an oil leak coming from the distributor with a new O-ring. The wipers were dried out, so I splashed out on some PIAA ones. My car had been running poorly since I installed a new ignition control module, which was done purely to refresh the distributor completely...

Have you been running standard arms this whole time?

Crank position sensor?

Quote that part number and see if they can get it.

Honda still sells them.

You can find that stuff on eBay or Amazon. Very generic of course. https://www.amazon.com/BENLIUDH-Automotive-Harness-Engine-150pcs/dp/B0BFF8DRL8 Can even try Temu if you want.